Cheap, reversible AK fixes you can do in an afternoon
Gun Digest put together a rundown of cheap, garage-level AK upgrades that any owner with basic tools can knock out in an afternoon, and most of the fixes cost next to nothing.
Snapshot
The piece walks through a handful of classic DIY AK mods performed on a plain Romanian "G" kit build, with the author noting the whole batch can be done for under $20. Each fix addresses a known AK annoyance, from tiny iron sight notches to hot handguards and awkward safety levers, and the author points out that every modification can be reversed or swapped out if you don't like the result.
Key points
- Sights: Widening the rear sight notch to between 0.135 and 0.145 inch with a triangle file speeds up target acquisition without hurting accuracy much, according to the author.
- Handguard heat shield: A cut section from an empty beer can (a cheap one, since some pricier cans have plastic liners) slides into the lower handguard to block heat.
- Light mount: A scrap of Picatinny rail, four washers and two longer screws let you bolt a light to the handguard using factory hardware points.
- Sling and safety tweaks: Coated steel cable and ferrule stops build a sturdier front sling loop, while contouring the safety's auto tab and adding a Dremel notch lets the bolt lock to the rear and makes a semi-auto-only safety safer to handle, the author says.
- Grip and polish: AR-style grips can be hogged out with a Dremel to fit AK hardware, and a light polish on rails and bearing surfaces smooths function without sanding.
Quick take
None of this is groundbreaking, but that's the point: these are the same low-cost tricks AK tinkerers have leaned on for years, repackaged for shooters who want a weekend project without buying a pile of aftermarket parts. If you're not handy with a Dremel or a file, the author notes commercial alternatives exist for nearly every fix here.
Read the full story: gundigest.com