Restoring a 1927 Browning Auto-5, One Part at a Time
A pandemic-era barbershop detour turned into a full restoration project when the author's wife picked out a beat-up FN-made Browning Auto-5 for $400, cut-down barrel, construction screws and all.
Snapshot
Gun Digest walks through a months-long DIY rebuild of an early FN Browning Auto-5, likely dating to around 1927 based on its serial number and proof marks. The project swaps out the original wooden spring parts, repairs a cracked forend, and fits the stock specifically to the owner's wife, proving that a rough old classic can be brought back without a gunsmith's full workshop.
Key points
- Modern parts fix an old flaw: The wooden spring plug and spring were replaced with a Sure Cycle Auto-5 Action Cycle Kit, swapping in a machined aluminum part for a century-old weak point.
- Crack repair preserved the checkering: A crack at the forend's base was filled with Miles Gilbert BedRock epoxy bedding, while Citristrip, steel wool and 600-grit sandpaper stripped the finish without damaging the factory checkering.
- Custom length of pull: The stock was cut to a 12.5-inch length of pull and fitted with a Pachmayr F325 Deluxe recoil pad, then hand-shaped to the receiver tang for a precise fit.
- Finish and small upgrades: A homebrew Minwax stain and thinned Birchwood Casey True Oil gave the wood a period-correct look, while a fiber-optic front sight replaced the missing bead and the magazine tube got polished for reliability.
- History matters: Proof marks, including a crowned ELG and "ACIER SPECIAL" stamping, point to Belgian Liège production, and a worn metric chamber marking hints at the shotgun's original European shell length.
Quick take
This is a solid blueprint for anyone sitting on a rough old Auto-5 that deserves better than a dusty closet. The mix of off-the-shelf parts, patient woodworking, and attention to proof marks shows that restoration doesn't require rare factory replacements, just the right technique and time.
Read the full story: gundigest.com